Williams Sound WIR 250 Betriebsanweisung PDF herunterladen (Seite 14)

In Case of Difculty

If the system does not seem to be functioning:

1. Read through the manual and user guide carefully to verify proper

setup and installation of your system.

2. Make sure that your television or VCR is plugged in and turned on.

3. Make sure that the TX240 Transmitter’s power adapter is plugged in.

4. If you’ve installed the TX240 Transmitter other than on top of the TV,

make sure that its front panel is facing the receiver.

5. Make sure that the receiver has a fully charged battery.

6. Make sure you are not covering the infrared “eye.” Remove any

objects obstructing the line between the TX240 Transmitter and the

receiver. The “TV TALKER” label should be facing towards the TV

while you listen.

7. If you are using the RX240 or RX250 Receiver and getting static or

hiss: Try operating the TX240 Transmitter in MONO (2.3 MHz or 2.8

MHz) mode. See instructions on page 8.

8. If you are operating the TX240 Transmitter in MONO (2.3 MHz or 2.8

MHz) mode and getting noise or hiss in the receiver: For 2.3 MHz

operation, check to make sure you are only using the left RCA jack

on the TX240 Transmitter. For 2.8 MHz operation: make sure you are

only using the right RCA jack on the TX240 Transmitter.

9. If you are using the TV microphone and not getting a signal, try

turning up the TV volume up slightly. Also, try positioning the TV mic

directly over the TV speaker.

10. If the system still does not function, call Williams Sound at:

1-800-843-3544.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Williams Sound WIR 250 Betriebsanweisung Seite 14