Williams Sound PFM 360 Betriebsanweisung Seite 5

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 14
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 4
Motiva® Personal FM Wireless Listening System
MAN 146i
3
Using the PFM T36 Transmitter
IMPORTANT: If Alkaline (nonrechargeable) batteries are being installed, slide the battery selection switch in the
battery compartment to the “Alkaline” position. See FIG 1 below. If installing NiMH (or rechargeable) batteries, slide
the battery selection switch to the “NiMH” position.
FIG. 1: Battery Selection Switch
1. Install two (2) AA batteries. Note: rechargeable batteries must be charged before use. See Battery Information on page 6.
2. Plug the microphone cord into the “Mic Jack” ( ) on top of the transmitter.
Note: The microphone with 39 inch cord MUST be used with the Transmitter.
3. Optionally, plug in a desired audio source such as a CD or MP3 player using the “Auxiliary Input” jack (WCA 087 stereo auxiliary
input cable included). If the microphone and an auxiliary source are used together, the audio will be mixed. If only the auxiliary
source is desired, the microphone can be muted. Do not remove the microphone from the “Mic Jack” as the microphone’s
cable is also the transmitting antenna!
4. Turn the unit on: press and hold the “ON/OFF/MUTE” button for three seconds. The “Power On” indicator ( ) should illuminate
green.
5. Select the desired operating frequency. Use the “Channel Selector” knob to select any of the 16 available channels on 72-76
MHz. Refer to the channel selection chart (Page 6). Make sure the receiver is operating on the same frequency as the
T36 transmitter.
FIG. 2: PFM T36 User Controls
AA
AA
+
+
Comp
CH Lock
- Gain + -
AUX
+
2:1
1:1
A123
ALKALINE/
NiMH SWITCH
AUXILIARY
INPUT
MIC JACK
ON/OFF, VOLUME
CONTROL SWITCH
CHANNEL
SELECTOR
POWER "ON"
INDICATOR
A300
6. Place the transmitter in a pocket, or clip it onto a belt or waistband (See “BELT CLIP INSTALLATION”, page 8).
7. Lapel clip microphones should be attached to a collar or lapel, as close to the speaker’s mouth as practical. If using an optional
headset microphone, position the mic as close to the side of the mouth as possible without touching the mouth See FIG 3
Page 4.
8. To mute the microphone, press the “ON/OFF/MUTE” button momentarily. The “ON/OFF/MUTE” button will ash red. To unmute
the microphone, press the “ON/OFF/MUTE” button momentarily again.
Seitenansicht 4
1 2 3 4 5 6 7 8 9 10 ... 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare