Williams Sound WIR TX8 Installationsanleitung PDF herunterladen (Seite 17)

Williams Sound

Helping People Hear

IR RECEIVER MODELS WIR RX3, WIR RX7, WIR RX8

Make sure the “eye” on the front of the receiver is not covered up when in use. The receiver is intended to be

worn on the front of the body, hanging from the lanyard attached to the receiver. The receiver will not work if

it is placed in a pocket or purse. A variety of earphones, headphones, or neckloop telecoil couplers can be

used with RX3, RX7 and RX8 Receivers.

Step 1: To install batteries in the RX7, or RX8, open the battery compartment using a coin in

the slot in the bottom of the receiver. Press two AA batteries into place, observing proper

battery polarity.

Step 2: Plug the earphone or headphone into the earphone jack.

Step 3: Turn the receiver on by rotating the volume control knob clockwise.

Step 4: Adjust the tone to your preference using the slide switch tone control. (Not on the RX3 or

RX4) To avoid draining the battery, make sure the receiver is turned off when not in use.

BATTERY INFORMATION

For RX7, or RX8 Receivers in normal use, two AA alkaline batteries (BAT 001) will last about 30 hours.

Rechargeable AA batteries (BAT 026) will last about 15 hours per charge. (The RX3 uses a 9V battery.)

If you are using BAT 026 rechargeable batteries, use the CHG 200A Multi-Charger. Contact your dealer or

Williams Sound for details.

If the sound becomes weak or distorted, replace the batteries. The indicator light may still be on, even with

weak batteries. Do not leave dead batteries in the receiver, they may leak and damage the receiver.

RECEIVER MANAGEMENT

Different types of facilities will use different approaches for receiver management and earphone sanitation. Below

are some options that customers have used successfully.

 Regular users purchase their own receiver and take care of their own batteries and earphone.

 Some facilities label the receiver and earphone with the names of regular users so each person uses the same receiver

and earphone.

 Ushers issue receivers to people who request them. Earphones are sanitized after use. Foam ear cushions can be

replaced or washed with a mild detergent, rinsed thoroughly and air-dried. The EAR 022 Surround Earphone can be

sanitized with an alcohol pad.

 The receivers can be stored in a multiple compartment storage case with a credit card or

driver's license left as collateral for the receiver.

!! IMPORTANT WARNINGS !!

DO NOT ATTEMPT TO RECHARGE ZINC CARBON (“HEAVY DUTY”), ALKALINE, OR LITHIUM

BATTERIES!

DO NOT ATTEMPT TO RECHARGE DISPOSABLE BATTERIES!

These batteries may heat up and

explode, causing possible injury and damage to the equipment.

Avoid shorting the plus and minus battery terminals together with metal objects. Battery damage

and burns can result!

Use only Williams Sound supplied charger and batteries!

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Williams Sound WIR TX8 Installationsanleitung Seite 17