Williams Sound DLT 100 2.0 Bedienungsanleitung PDF herunterladen (Seite 14)

DLT 100 2.0 Digital Transceiver and DLR 60 2.0 Digital Receiver

DLR 60 2.0 Controls

DLR 60 2.0 Operation

1. Insert 2 AAA batteries into the DLR. Be sure to observe correct polarity. You can use either Alkaline or NiMH, but make sure the

battery switch is in the NiMH position to charge NiMH batteries. If Alkaline batteries are used, put the battery switch in the ALK

position.

2. Power on/o by holding the power button

for 3 seconds.

3. In 1-way mode, the DLR will seek active DLT’s; press channel button up or down to seek next active DLT. In 2-way mode,

group must be selected.

4. The Antenna Symbol will ash, and there will be no Signal Strength Bars, if not synchronized with a DLT 100 2.0.

5. If the units are synchronized, briey push the power button

to show group assigned (0 to 99).

6. To change group, hold the

and buttons for 3 seconds until “GROUP” is ashing.

7. Use

or buttons to select group number.

8. Hold

and

buttons for 3 seconds again to save the group number.

9. To change volume level press

or buttons, display will show 00 through 30.

10. User can listen using the speaker on the back of the DLR or by plugging in stereo or mono earphones into the jack (which

defeats the speaker operation).

11. Low battery indicator will show as a blinking battery symbol with no bars inside it.

12. The DLR will automatically power down after 5 minutes if not synchronized with a DLT.

A467

RED LED

GREEN LED

CH/GROUP

CHANGE

VOLUME

ADJUST

POWER

HEADPHONE

JACK

SPEAKER

BATTERY

STRENGTH

BATTERY TYPE

SWITCH

LANYARD

SLOT

DOCKING

CONNECTOR

STRENGTH DLT#1

STRENGTH DLT#2

NUMERIC DISPLAY

NUMERIC TYPE

ANTENNA

SYMBOL

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Williams Sound DLT 100 2.0 Bedienungsanleitung Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Empfänger Williams Sound DLT 100 2.0