Williams Sound WIR TX8 Installationsanleitung PDF herunterladen (Seite 16)

TROUBLESHOOTING

NEITHER TX8 INDICATOR LIGHT IS ON (FIGURES 1B, 10 & 11).

 Make sure the wall transformer is plugged into the emitter and the power switch or any

remote power switch is on.

 Make sure the electrical outlet is on.

 Make sure the 24 VAC power supplies are working.

ONLY TX8’S POWER INDICATOR LED COMES ON (FIGURES 1B, 10 & 11).

 If the TX8 is connected to a TX10 infrared system: make sure the TX10 power indicator

is ON and check to make sure there is an active audio source coming into the TX10

 If the TX8 is connected to a 95/250 kHz compatible modulator: make sure the modulator

power indicator is ON and check to make sure there is an active audio source coming

into the modulator

NO SOUND THROUGH RECEIVERS.

 If some of the receivers work but others don’t, check for bad batteries or earphones on

the receivers that aren’t working.

 If none of the receivers work, check to see if the power and baseband cable are connected

to the emitter and that the Power and Baseband Indicator lights are ON.

 If a 95/250 kHz compatible modulator is being used, check to make sure it is properly

connected to the sound system. The On Indicator on the modulator should be lit and

there should be activity on modulator’s level indicators.

 Make sure the “eye” is not covered up on the receiver. There must be clear line of sight

between the receiver eye and the emitter panel.

 Make sure the selected modulator frequency matches the selected receiver frequency.

SOUND THROUGH THE RECEIVERS IS WEAK AND NOISY.

 Try increasing the input signal level from the sound system by turning up a mixer

control. If the signal sounds okay, you may need to re-position the emitter panels or add

additional panels.

NOTE: Make sure the powerline voltage does not fall below 94V, or system

performance will be greatly reduced!

BUZZING OR HUMMING NOISE IN SOUND SYSTEM.

 Check for ground loops or noise on the input signal. Call your Authorized Dealer or

Williams Sound for help.

1 2 ... 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Williams Sound WIR TX8 Installationsanleitung Seite 16